LevelOne GVS-3800 - Manual (Page 23)

17
3-3-4. Port Configuration
Function name:
Port Configuration
Function description:
Change the state and configuration of each port. This page could set local
device’s port status, include work mode, flow control ability, ingress and
egress rate limit.
Parameter description:
Port:
The TP Port is MEDIA CONVERTER’s Ethernet UTP interface.
The FX Port is MEDIA CONVERTER’s Ethernet Fiber interface.
Link:
Show port current link status:
100F = Speed 100M, Full Duplex Mode
100H = Speed 100M, Half Duplex Mode
10F = Speed 10M, Full Duplex Mode
10H = Speed 10M, Half Duplex Mode
Down = Link Down
Mode:
The Auto Speed algorithm to exchange the capability with the linked
partner. When enabled, the speed, duplex mode and flow control mode
may change. You must have both port configuration of local port and
linked partner be the same. If their configuration is different, the link will
not be set up successfully. In WEB SMART MEDIA CONVERTER, fiber
port supports forced mode only.
Set the mode of speed and duplex. In speed, 10/100Mbps baud rate is
Fig. 3-8 Port Configuration