LevelOne WBR-6022 - Manual (Page 50)

50
Low Power Wireless Mode: When no wireless clients are connected to the router, it will reduce
power to the radio to save power. When a device connects wirelessly to the router, it will revert to full
power immediately.
Sleep Mode: When Enabled, the router will follow the times set in the schedule below to enter Sleep
Mode, or wake up to normal mode. When the router is in Sleep Mode, the user will not be able to
connect to the Local network, nor the Internet.
Note: The Sleep button on the back of the router can override the current router setting. You
can force the router to enter Sleep Mode, or revert back to normal mode.
Smart Schedule: When Enabled, the router will first check whether there is any network activity on
router before entering Sleep Mode. This is to prevent your network usage to be interrupted.
Bootup / Sleep Time Log: A log of the times that the router entered Sleep Mode, or woke up back to
normal mode.
Primary Setup
This page lets you change the LAN (Local Area Network) settings on your WBR-6022 Wireless
HomeGuard 22 Router and WAN (Wide Area Network) connection.
LAN IP Address: The local IP address of this device. The computers on your network must
use the LAN IP address of your product as their Default Gateway. You can change it if
necessary.
WAN Type: WAN connection type of your ISP. You can use the drop-down men to choose the
most suitable one from the following options:
Connection Control: You can choose the method that the router maintains connection to the
internet.