LEDGlow Home Theater Kit - Manual (Page 2)

Kit Operation and Using the IR Remote
Memory Function:
The memory function will only work
with solid color modes. Set the kit to
your desired solid color, press M then
either 1, 2, 3, or 4 and your color
option will be saved. Color Adjustment:
Press to move forward through all
available color options. The cycle will take
20 seconds to complete.
Press to move backward through all
available color options. The cycle will take
20 seconds to complete.
Once the kit is in either of these modes,
press the pause button to stop the fade
mode. To slowly step between colors, press
to you reach your desired
color. Then follow the steps in the memory
function section to save your custom color!
Sleep Function:
The timer will power your kit down
after a certain amount of time. Press
the SLEEP button then 1, 2, 3, or 4 and
the power will turn off in 1, 2, 3, or 4
hours
Brightness Mode:
The brightness mode will only work when
the kit is set to a solid color. Press to
increase brightness and press to
decrease the brightness.
Turns the Kit On/Off Speed Adjustment:
Adjusts the speed of fade mode, and will
adjust the sensitivity of the sound activation
modes.
Puts the kit into a Million Color Fade
Mode. Puts the kit into a sound activated mode.
Colors vary according to intensity of the
sound.
Puts the kit into a fade mode. Press
again to pause on custom colors.
Factory Reset:
Pressing these buttons in succession will set
the kit back to factory defaults. If successful,
you will see all of the lights flash once.