LEDGlow 8pc Truck Bed Lighting Kit - Manual (Page 2)

6. Attach the wire that you just connected to the positive 12 volt source to the #1 post on the on/off switch using the
supplied female spade connector. Note: The posts are numbered on the side of the switch.
7. Connect both power wires with the white stripe to the #2 post on the on/off switch using the supplied female spade
connector. Note: If you want to use an existing or different switch than the one provided, be sure to verify the switch is
rated for 12 volts and follow specific instructions for the switch.
8. Connect both power wires that are solid black to any unpainted, bare metal grounding source or to the negative terminal
of the battery.
9. Secure all the excess wire with zip ties.
10. Once the Truck Bed Lighting Kit is installed and powered, ensure all of the lights are functioning properly.