LEDGlow 7 Color Slimline Truck LED Underbody Kit - Manual (Page 3)

16. Beginning with Tube A, connect each tube to the next using the modular connectors. Make sure to secure the wires tightly when
going around the suspension and/or exhaust. Leave at least 8 inches between the exhaust and the underbody tube.
17. Once all of your connections have been made, and you have tested the kit to ensure all connections are secure, seal each
connection using the included self-sealing tape. This ensures the connections will not get wet and cause your kit to fail.
18. It is imperative to make sure that the wires are not mounted to any direct heat source or to any moving parts. Any excess length
on the tube power wire will have to be bound up and secured tightly.
19. DO NOT SHORTEN OR CUT ANY OF THE UNDERBODY TUBE POWER WIRES. This will destroy the kit and void
all warranties.
20. Lower the vehicle if it was raised, power on and test the underbody kit for full functionality.
21. Once the vehicle is on the ground, turn the steering wheel as far as it can go in both directions to ensure the tubes and/or wires
are not coming in contact with your tires or any other moving parts.
For accessories, replacement parts and/or technical support, please visit www.LEDGlow.com for more information.
Using the Control Box & 4 Button Wireless Remote
Mode Change Button
Pressing this button on the control box or wireless remote allows you to select from 17
distinct patterns. The 17 available patterns are listed below.
Solid On Solid Flash Solid Flash 2 Flashing Scan
Counter Clockwise
Circle Counter
Clockwise Off Counter Clockwise
Section Flash Clockwise Section
Flash
Center to End Section
Chase End to Center
Section Chase End to Center
Section Flash Music Mode A:
Brightness Fade
Section Flashing Scan Counter
Clockwise
Scan Scan Center Flash to
Solid Flash
Music Mode B: Counter Clockwise Scan
Speed Change Button
Pressing this button on the control box or
wireless remote will allow you to select
from 5 different speeds for your selected
pattern.
If your kit is in music mode, this button
will adjust the sensitivity of the selected
music mode.
Color Change Button
This button is used to select from the 7 distinct solid color modes, as well as 1 multi-color
flash and 1 multi-color fade mode. The available solid color modes are listed below.
Red Green Blue Yellow Purple
Teal White 7 Color Flash
Mode 7 Color Fade
Mode
Power Button
This button is used to power your kit on
and off.