LEDGlow 4pc.-10pc. Single Color Wireless LED Underbody Kit - Manual (Page 3)

Adding or replacing your wireless remote
1. The included wireless remote is already pre-programmed. This setup is only needed when replacing an existing remote or by adding additional remotes to your
system. You may program up to 3 remotes to each control box.
2. In order to program the remote to the control box you must turn the kit off.
a.
First Remote - Press and hold the mode button on the remote and the mode control box on the control box for 5-7 seconds. Test the operation with the
remote.
b. Second Remote - Press and hold the mode button on the remote and the mode control box on the control box for 5-7 seconds. Test the operation with the
remote.
c. Third Remote - Press and hold the mode button on the remote and the mode control box on the control box for 5-7 seconds. Test the operation with the
remote.
Once you have installed your LED lighting kit, power the kit on using the 4 button wireless remote or the buttons located on the control box to
ensure that it is fully functional.
Using the Control Box & 4 Button Wireless Remote
Power Button

Pressing this button on the control box or wireless remote will turn your kit on and
off.
Speed Change Button

Pressing this button on the control box or
wireless remote will allow you to select from 5
different speeds for your selected pattern.

If your kit is in music mode, this button will
adjust the sensitivity of the selected music mode.
Mode Button
 Pressing this button on the control box or wireless remote allows you to
change the current pattern displayed on your kit. There are 12 distinct
patterns, as well as 5 unique music modes. The patterns are listed below:

Solid Illumination Mode

Flashing Mode

Flashing Front Chase

Flashing Back Chase

Steady Front Chase

Steady Back Chase

Front Running Chase Mode

Back Running Chase Mode

Outside to Inside Flash

Inside to Outside Flash

Flash Pattern

Flash Pattern

(5) Sound Activation Modes
Color Change Button
 This button is not used with LEDGlow’s Single
Color LED Underbody Kit.
For accessories, replacement parts and/or technical support please visit www.LEDGlow.com for more information.