Hochiki SMB-ADAPTOR - Manual

Hochiki Europe (UK) Ltd
2-3-0-1501/ISS1/OCT11
SMB-ADAPTOR INSTALLATION INSTRUCTIONS
Products Covered: SMB-ADAPTOR, SMB-1, CHQ MODULES, CHQ ‘MINI’ MODULES,
CHQ-ADAPTOR
Introduction
The SMB-ADAPTOR is a mounting plate designed to be fitted within the SMB-1 module enclosure to facilitate the
mounting of the CHQ range of modules and ‘mini’ modules. The CHQ range of modules is fitted utilising the
CHQ-ADAPTOR, an adaptor which allows the PCB assembly of the CHQ Module to be removed and mounted
within enclosures. The ‘mini’ modules such as the CHQ-POM can be fitted directly to the SMB-ADAPTOR plate.
Example
The above example shows how a single CHQ Module can be mounted within the SMB-1 enclosure utilising the
CHQ-ADAPTOR and the SMB-ADAPTOR plate. For further information on removing the CHQ Module PCB
Assembly please refer to the CHQ-ADAPTOR Instructions (2-3-0-795).
NOTE: When disassembling the CHQ Module in preparation for mounting onto the CHQ-ADAPTOR please be
aware that the device features a printed circuit board (PCB) which contains electro-static sensitive components.
Observe precautions for handling these components to avoid damage to the unit.
SMB-ADAPTOR - Typical Configurations for SMB-1 Enclosure
SMB-ADAPTOR with 1 CHQ-ADAPTOR (+ PCB)
(fitted landscape)
SMB-ADAPTOR with up to 4 ‘mini’ CHQs
(for example, CHQ-POM)