Arcam P85 - Manual (Page 13)

A85/P85
13
English
Service information
A85 P85
Continuous power output, per channel
Both channels, 8
Ω, 20Hz–20kHz 85W 85W
Single channel, 4 Ω, 1kHz 140W 140W
Distortion, 8 Ω, 80% power, 1kHz 0.005% 0.005%
Inputs
Phono cartridge (optional module):
input sensitivity, MM 2.5mV
input sensitivity, MC 250µV
Line and tape inputs:
Nominal
sensitivity 250mV 700mV
Input impedance 22k Ω 22kΩ
Signal/noise ratio (CCIR) 105dB 112dB
Tone controls, max. boost/cut ±12dB
Preamplifi er outputs
Nominal output level
700mV
Output impedance <3 Ω
General
Power consumption (maximum)
800VA 800VA (950VA for P85/3)
Dimensions W x D x H (including feet) 435 x 340 x 100mm 435 x 320 x 100mm
Weight (net) 9kg 9.5kg (10.5kg for P85/3)
Weight (packed) 10.5kg 11kg (12kg for P85/3)
Supplied accessories mains lead mains lead
CR-389 remote control
2 x AAA batteries
E&OE
Continual improvement policy
Arcam has a policy of continual improvement for its products.
This means that designs and specifi cations are subject to
change without notice. NOTE: All specifi cation values are typical unless otherwise
stated.
Before returning your amplifi er for service, please check the
following:
Sound cuts out for no reason
If the temperature of the internal heatsink rises above a safe
level, then a thermal cutout inside the amplifi er will operate.
The power indicator on the front panel fl ashes and the
protection system temporarily removes the power to the
speakers. The system resets itself as the heatsink cools down.
Note that because of the high output voltage from a CD player,
it is possible to drive the A85 at full power even though the
volume is not set at maximum.
Amplifi er does not switch back on
The A85 and P85 amplifi ers have a protection mechanism
which is activated if you switch the unit on immediately after
turning it off. If this mechanism activates, wait 30 seconds
then try again.
Technical specifi cations
A85/P85 multi.id 03/29/01, 3:46 PM 13