Harrington Hoists and Cranes (N)ERCC Hoist - ((N)ER2) - Manual (Page 9)

4.0 Operation
4.3 Hoist Controls
4.3.1 Single Speed Hoists – Firmly hold the black Grip on the cylinder control. Slide the Up/Down Switch
Operator up to raise the load or down to lower the load as shown in
Figure 4-1 . To stop the hoist slide
the Up/Down Switch Operator back to the middle position.
4.3.2 Dual Speed Hoists – Select high or low speed using the Speed Selector Switch. Lights ajacecnt to the
Speed Selector Switch indicate if low or high speed is selected. Slide the Up/Down Switch Operator up
to raise the load or down to lower the load
Figure 4-1 . To stop the hoist slide the Up/Down Switch
Operator back to the middle position.
4.3.3
CAUTION
Make sure the motor completely stops before reversing direction.
Single Speed Dual Speed
Figure 4-1 Cylinder Control Operation
9