Grove Gear Stainless Steel - Manual (Page 6)

Instruction Manual
Phone: (262) 878-1221 Fax: (262) 878-1968 5
Standard Speed Reducer Mounting Positions & Vent Plug, Level and Drain Locations
Maintenance - Standard Units
Your Grove Gear reducer has been tested and adjusted at the factory. Dismantling or replacement of components must be done by
Grove Gear to maintain the warranty.
Frequently check the oil level of the reducer. If oil level is low, (refer to reducer vent and level position chart) add proper lubrication
through the filler plug until it comes out the oil level plug.
Inspect vent plug often to insure it is clean and operating.
Mounting bolts should be routinely checked to ensure that the unit is firmly anchored for proper operation.
Seals: The Grove Gear line of speed reducers utilize premium quality seals which are the state-of-the-art in sealing technology. Seals
are, however, a wear item and eventually need to be replaced. Replacement can be easily accomplished by following the steps below:
1. Remove the worn seal without damaging the shaft surface or the seal bore. This can be done by drilling a .062
diameter hole in the seal casing (being careful not to drill into the bearing behind the seal). Screw a #10 sheet metal
screw into the hole and pry out the seal.
2. Clean the seal bore of sealant.
3. Before installing the new seal, use electrical tape to cover any keyways on the shaft to prevent seal lip damage.
4. Grease the seal lips with bearing grease and apply a sealant to the seal bore.
5. Slide the seal into the shaft being careful not to fold the inner lip over on any shaft steps.
6. Press the seal into its bore with a sleeve that presses on the seal casing, being careful to keep the seal square in its
bore.
CAUTION
Instruction Manual
Maintenance
Inspect the stem of the pressure compensating system often to ensure it is clean and operating properly.
Mounting bolts should be routinely checked to ensure that the unit is firmly anchored for proper operation.
Class of Service
All capacity ratings are based on American Gear Manufacturers Association (AGMA) Standards. Load conditions must be within cata-
loged ratings published in the current Grove Gear Catalog (available upon request).
CAUTION
Parts List
} Units with
an internal
pressure
compensation
system
A Regal Brand
1524 15th Avenue
Union Grove, WI 53182 U.S.A.
PH: 262-878-1221
FAX: 262-878-1968
www.grovegear.com
©2012 Regal-Beloit Corporation 7313G/1K/08-12/BH/MER
Ratio Multiplier
Speed Reducers
Installation, Lubrication and
Maintenance Instructions
A Regal Brand