Grant Part #5646 - Single Horn Button Billet Housing - Manual

GRANT CLASSIC/CHALLENGER BILLET HORN BUTTON
INSTALLATION INSTRUCTIONS
This assembly will replace the present metal horn cap, spring, retainer contactor plate(s) and shoulder bolts currently
on your GRANT steering wheel.
TO INSTALL
1. Disconnect the battery or remove horn fuse so that the horn will not short out and blow during installation.
2. Pull or pry off metal horn cap and remove along with the spring. Disconnect the wire lead(s), remove the three
shoulder bolts and remove the fiber contactor ring (and copper plate present on many Ford vehicles). You should
now have nothing in the center of the wheel except the steering shaft retaining nut or bolt.
3. Separate the horn button from billet housing by pushing out from the back side. Position billet housing on wheel
and feed horn lead(s) through hole provided. Install three (3) cap screws provided and tighten to 10-12 ft/lbs. Do
not over tighten these bolts or damage to the hub may result.
4. On one (1) wire lead systems, connect the horn lead to the center terminal on back of horn button. On two (2)
wire horn systems used on many Ford vehicles you must make the following modification as the horn button
must not be grounded. Once done connect one wire lead to each terminal on back of horn button.
5. Install button into billet housing, reconnect battery or install fuse and enjoy your new GRANT accessory.
Rev. 5/09 by JF 97527-09-01