Grant Part #52203 - Revolution User Manual
Grant Accessories for air

2005-2010 FORD MUSTANG AIRBAG STEERING WHEEL
REPLACEMENT PROCEDURES
Congratulations on the purchase of your new GRANT REVOLUTION steering wheel. This wheel is a
direct replacement for your original factory steering wheel. The original airbag (SIR) module, horn
switch, switch harness, switches and rear shroud from the factory wheel must be removed and
transferred to the new GRANT wheel.
This wheel will fit Mustang vehicles equipped with spoke mounted cruise control switches and silver
spoke trim only.
IMPORTANT - PLEASE READ
These GRANT Instructions use the factory shop manual procedures for the removal and
reinstallation of the steering wheel and airbag module. In addition the GRANT instructions
include step-by- step procedures for the changeover of the switches, wiring and trim pieces from
the factory wheel to the Grant wheel. Before proceeding with the replacement of your original
steering wheel, it is necessary to read and understand all these instructions. By reading them
first, you can become familiar with the steps and terminology used. Please take note of the
following directives used throughout these instructions:
ALWAYS
CAUTION
NEVER
NOTICE
NOTE
NOTICE
- GRANT recommends that installation be performed by a qualified service provider such
as your local Ford dealer, a certified mechanic, collision repair shop or a local airbag service
center. Many of these service centers will come to your home or place of business to change out
the air bag and wheel for a nominal fee. To find these providers check the internet for “airbag
service”, “mobile airbag service” or check the yellow pages.
CAUTION
ALWAYS WEAR SAFETY GLASSES WHEN REPAIRING OR HANDLING AN AIR BAG.
ALWAYS CARRY A LIVE AIR BAG MODULE WITH THE TRIM COVER POINTED AWAY FROM YOUR
BODY.
ALWAYS PLACE A LIVE AIR BAG MODULE ON A BENCH OR OTHER SURFACE WITH THE TRIM
COVER FACING UP.
NEVER
PROBE THE CONNECTORS ON THE AIR BAG MODULE.
AIR BAG MODULES WITH DISCOLORED OR DAMAGED COVERS OR DEPLOYMENT DOORS
MUST BE REPLACED, NOT REPAINTED.
Tools required: T-20 and T-30 Torx Drivers
Socket Set
Safety
Glasses
Torque
Wrench
Flat
Blade
Screwdriver
DISABLING AND REMOVAL OF THE AIRBAG MODULE
1. Position the steering wheel so that it is pointed straight ahead. Write down all of your radio presets
as these may be lost when you disconnect the battery cable in step 2 below.
2. At the Smart Junction Box (SJB) located in the right hand lower kick panel, remove the cover and pull
the Restraints Control Module (RCM); this should be fuse number 17 (10A). Turn the ignition to ON
and monitor the airbag indicator light for at least 30 seconds, the light should remain lit continuously if
the correct fuse has been removed. If it does not remain lit you have pulled the incorrect fuse and
MODEL NUMBER