Sonnet Technologies Echo Express SE Thunderbolt Expansion Chassis - Manual (Page 10)

6
Chapter 3 – PCIe Card Installation Steps
Figure 8
Figure 7
11. Using two of the screws you removed previously, secure the back
edge of the Echo Express SE’s outer case to its inner assembly;
do not overtighten the screws
(Figure 7).
12. Turn the Echo Express SE chassis upside-down, and then using the
remaining two screws you removed previously, secure the bottom of
the outer case to the inner assembly; do not overtighten the screws
(Figure 8).
13. Turn the Echo Express SE right-side-up.
14. Connect a Thunderbolt cable between either
Thunderbolt port on the Echo chassis and a
Thunderbolt port on the computer (or other
Thunderbolt device in the chain connected to the
computer).
15. Connect the included power cord between a wall outlet or
power strip and the power adapter; verify the connector is plugged in
securely. Note that the power adapter’s power indicator will light at this
time.
16. Connect the power adapter cable to the Echo Express SE’s 12V power
socket. Note that the power indicator on the Echo Express SE chassis
will not light until the computer, and any other Thunderbolt device
connected between it and the Echo chassis, is powered on.