Sonnet Technologies xMac mini Server 2H - Manual (Page 8)

Chapter 3 – Computer, PCIe Cards, and xMac mini Server 2H Installation Steps
A – PCIe Cards Installation Steps
1. Remove the xMac mini Server 2H from its packaging, and then set it on
a flat, level surface.
2. Loosen the two captive thumbscrews securing the top cover to the
rest of the enclosure (Figure 1).
3. Slide the top cover back and up to remove it (Figure 1).
4. Remove the strap securing the cables to the floor of xMac mini,
remove the loose Thunderbolt cable and set it aside, and then move
the rest of the cables aside
(Figure 2).
Support Note: To avoid damaging components due to static
electricity discharge, wear an antistatic wrist strap while working
inside xMac mini Server 2H.
Figure 1
Figure 2
4
WARNING: When handling computer products, take care to prevent
components from being damaged by static electricity; avoid working
in carpeted areas. Handle expansion cards only by their edges and avoid
touching connector traces and component pins. Also, avoid touching the
xMac mini Server 2H’s circuit boards and any of its components.