Sonnet Technologies Fusion R400Q (Without Drives) - Manual (Page 4)

Drive Installation and Enclosure Setup
4
1. Remove the Fusion R400Q from its packaging, and place it on a
flat, level surface.
2. If you intend to place the Fusion enclosure on a desktop or other
flat surface, attach the included adhesive-backed feet to the
bottom of the enclosure
(Figure 3).
3. If you intend to use the Fusion enclosure in a rack, install the
Sonnet rack slide set (or equivalent), sold separately:
•
FUS-RSS-P for 17–21.5" deep racks
• FUS-RSS-S for 23–26.5" deep racks
• FUS-RSS for 27–30.5" deep racks
• FUS-RSS-L for 29–32.5" deep racks
4. Push a lever release button in until the lever pops out, and then
pull the lever toward you to slide out and remove the drive tray
(Figure 4).
5. Remove a SATA drive from its packaging and set it in on a flat,
level surface with the label side down. Open the supplied tube
of threadlocker and apply a single drop to each of the four screw
holes on the bottom of the drive
(Figure 5).
6. Turn the drive tray upside down and lay it on top of the drive,
with the back of the tray facing toward the drive’s connectors
(Figure 6).
Figure 3
foot
WARNING: When handling computer products, take care to
prevent components from being damaged by static electricity;
avoid working in carpeted areas. Handle hard drives only by their
edges and avoid touching connector traces and component pins.
Figure 5
screw hole
screw hole
screw hole
screw hole
threadlocker
Figure 6
drive
drive tray
connectors
Figure 4
drive module
lever
lever release
button