Sonnet Technologies Fusion R400S RAID (With Drives) - Manual (Page 3)

Fusion R400S RAID Features
1
➊ ➋ ➍ ➌
➎
➏ ➐ ➑ ➒ ➓
➎ ➎ ➎
1 – Power Indicator LED
This blue LED lights when the Fusion R400S RAID is
powered
2 – Rebuild Indicator LED
This orange LED lights when the Fusion R400S RAID is
rebuilding the data on a RAID 5 or 10 RAID set, or cloning
one drive to another drive when the system is set to Clone
mode
3 – Mode Change Confirmation; Drive 1 Presence, Activity,
and Fault Indicator LED
This LED lights red when the Drive Mode Change Switch is
pressed for more than three seconds. It also indicates Drive
1’s ready state (solid green), read and write activity (flashes
green), and fault status (OFF). Note that the LED will remain
off if the drive in drive bay 1 is not recognized
6 – Power Button
7 – Power Cord Socket
8 – Drive Mode Change Switch
Press and hold this switch for three or more seconds to
activate the selected drive mode
4 – Presence, Activity, and Fault Indicator LEDs for
Drives 2 – 4
These LEDs indicate the ready state (solid green), read and
write activity (flashes green), and fault status (OFF) for drives
2 – 4. Note that an LED will remain off if the corresponding
drive is not recognized
5 – Drive Modules
To remove a drive module, press its handle in until it pops
out, then pull out the entire module. To insert a drive
module, insert it into the drive bay until it stops, and then
push its handle in until it latches closed
9 – Drive Mode Setting Switch
Select the drive mode setting using this switch
10 – Locking eSATA Interface Port
This port is compatible with the included Sonnet locking
eSATA data cable and standard eSATA data cables as well
WARNING: Once you press and hold the Mode Change
Switch for more than three seconds while the R400S RAID
is powered, any files stored on the system are lost and cannot be
recovered!