beautypg.com

Drive installation and enclosure setup – Sonnet Technologies Fusion D400QR5 (Without Drives) User Manual

Page 5

background image

6. Carefully slide the drive module into the enclosure until its lever

starts to close, and then push the lever in until it clicks to secure
the drive module inside the enclosure

(Figure 7); verify that the

drive modules are all plugged in securely.

7. Repeat steps 2-6 for additional drives.

Connect Fusion D400QR5 to Computer and Power Outlet

1. Using one of the supplied cables (eSATA, FireWire 800, FireWire

400, USB), connect the Fusion D400QR5 to your computer. For
maximum performance, connect the D400QR5 to a SATA host
controller card.

2. Connect the supplied power cable between the Fusion D400QR5

and a grounded wall outlet or power strip;

verify the cable is

plugged in securely.

Drive Installation and Enclosure Setup

5

WARNING:

When inserting drive modules into the enclosure,

do not force the levers closed. If a lever does not close easily,

remove and reinsert the module, and then push the lever in again.

Figure 7

push lever

until it clicks

push tray in

until the lever

starts to close

Support Note:

The supplied Sonnet locking eSATA cable is

compatible with all eSATA ports and provides a far more

secure connection when used with Sonnet drive enclosures and host
controller cards with the matching connector. If necessary, you may
remove the locking mechanism from the connector by removing the
screws securing the two halves.