SKC 901-Series Flite 2 - Manual (Page 7)

www.skcltd.com 901-FTM Issue F Page 5
General Information
1) Care of the Flite 2 Pump
• The Flite 2 pump is supplied complete with a rubber dust cap for the inlet hosetail and a screw-in dust
cap for the charging/power socket. Please ensure that these are fitted at all times when the pump is not
in use or being charged.
• Never run the Flite 2 pump without a filter in line, to prevent dust from contaminating the pump mechanism.
• Always use the correct SKC batteries and battery charger designated for the Flite 2 pump.
• The Flite 2 pump casing is IP20 rated, it is not rated as water or splashproof and therefore must not be
used where it is possible for water to enter the pump casing.
Warning - Failure to follow these guidelines will void the product warranty.
2) The WEEE Directive
This product is marked with the crossed out wheelie bin symbol, which identifies that it falls within the
scope of the EC Directive 2002/96/EC on waste electrical and electronic equipment (WEEE). At the
end of it’s useful life, this product must be disposed of in an environmentally sound way as detailed in
the Directive. Please contact your local distributor or SKC Ltd for further details on how to comply with
the requirements of the WEEE Directive. SKC Ltd’s producer registration number is WEE/KH0054TQ.
3) The Batteries Directive
The lead/acid batteries supplied for use with this pump, fall within the scope of the EC Directive 2006/66/EC
on batteries and accumulators and waste batteries and accumulators. At the end of a battery’s life it must be
disposed of in an environmentally sound way as detailed in the Directive. Please contact your local distributor or
SKC Ltd for further details on how to comply with the requirements of the Batteries Directive. SKC Ltd’s batteries
producer registration number is BPRN00454.