SilverStone ST60F-PS - Manual (Page 2)

STRIDER PLUS SERIES
SPECIFICATION
SilverStone Strider Plus
ST60F-PS
ATX12V / EPS 12V Switching Power Supply
With Active PFC
80Plus Silver
PS/2
01
1.1 Scope
This specification defines the performance characteristics of a single phase 600watts,
5 output power supply. This specification also defines worldwide safety and
electromagnetic compatibility requirements for the power supply which is intended for
use in computer products.
1.General
2.1 Input Voltage
Nominal Voltage Voltage Variation Range
100-240 Vrms 90 - 264 Vrms
2.Input Characteristics
2.2 Input Frequency
Nominal Frequency Frequency Variation Range
50-60 Hz 47 Hz to 63 Hz
* The power supply must operate at above frequency with 90-264 VACrms input voltage range.
02
Output Voltage Load MIN Range MAX Regulation Ripple P-P Max.
1. +5V
2. +12V
4. –12V
5. +5Vs
6. +3.3V
0.2A
0.6A
0.0A
0.0A
0.1A
20A
49.0A
0.5A
3.0A
20.0A
±3%
±3%
±10%
±5%
±3%
50mV
120mV
120mV
50mV
50mV
2.3 Max. Input AC Current
Max. Input Current Measuring Range
8A 90 - 264 Vrms
2.4 Inrush Current
The power supply must meet inrush requirements for any rated AC voltage,
during turn on at any phase of AC voltage, during a single cycle AC dropout
condition, during repetitive ON/OFF cycling of AC, and over the specified
temperature range.
The peak inrush current shall be less than the ratings of its critical components
(including input fuse, bulk rectifiers, and surge limiting device).
2.5 Efficiency
SST-ST60F-PS provides an efficiency of 85% minimum when measured at full
load under 115V/60Hz condition.
3.1 Normal Operation Output
3.Output characteristics
Maximum continuous total DC output power should not exceed 600W.
Maximum continuous combined load on +3.3VDC and +5VDC outputs
shall not exceed 130W.
Maximum combined load on +12V outputs shall not exceed 588W.
NOTE:Noise test should be measured with 20 MHz bandwidth frequency
oscilloscope. The output terminal shall add a tantalum capacitor of 10uF in
parallel with a ceramic capacitor of 0.1uF.