Autostart AS-1727 User Manual

Page 8

P. 8 User

Guide

Flashing LED

The user may decide to turn on or off LED flashing at any moment. To do so, simultaneously press
and hold the

LOCK

and

UNLOCK

buttons on the transmitter. Keep holding the buttons until the

parking lights flash three (3) times. At that point release the buttons. The LED will toggle to its next
state –i.e.: ON/OFF:
There are three programmable options regarding the flashing LED:

i. The LED flashes once the starter kill is activated (passive or active arming) and will turn itself

off once the user turns the key to the

IGNITION ON

position.

ii. The LED is totally disabled and will not flash –it will turn on solid however when in valet

mode.

iii. The LED will flash once the starter kill is activated but requires pressing the

UNLOCK

button to

turn itself off. Failure to press the

UNLOCK

button will make the LED flash even if the key is in

the

IGNITION ON

position.

Safe Start

If this feature is enabled, the user must press the

START/STOP

button 2 times within 3 seconds to

remote-start the vehicle. This will eliminate accidental remote starts, e.g. when children are playing
with the transmitter.
If swap start mode is selected, to remote-start your vehicle, press the

PANIC/AUX

button and then

the

LOCK

button. The

AUX 2

output can be activated by pressing the

START/STOP

button.

Ignition-Controlled Door Locks

This is an added security feature. If your remote starter was installed with the ignition-controlled
door locks option, the doors will automatically be locked as soon as the ignition key is turned to the

IGNITION ON (RUN)

position while the brakes are pressed. When the key is turned to the

OFF

position,

the doors will automatically be unlocked.
Ignition Re-lock

On remote starters of this series, when ignition-controlled door locks are enabled and the ignition
key is in the

IGNITION ON (RUN)

position, should any door be unlocked and opened, all doors will be

relocked next time the brake pedal is pressed.
Secure Lock

Before it can remote-start your vehicle, the remote starter must first disarm the factory security
system. The secure lock feature may be required on certain vehicle models with factory security
systems that automatically unlock the doors when the security system is disarmed.
To keep your vehicle protected when the factory security system is disarmed for a remote start,
secure lock will relock your doors as soon as the vehicle has started. Once the engine run cycle
ends, secure lock will rearm your factory security system.
Turbo Mode

When left in turbo mode, the remote starter will keep the engine running for 60 seconds before
shutting it down. This is to allow a turbocharger to idle down after the user leaves the vehicle. See
Turbo Mode section on page 5.
Remote Trunk Release

If your system was installed with the remote trunk release option, you can open your trunk by
pressing the

TRUNK

button.

Engine Run Time

If you have a gas engine, your remote starter can be programmed to run the engine for 4, 15, or
25 minutes (15 minutes by default). If you have a diesel engine, the remote starter can be
programmed to run the engine for 9, 20, or 30 minutes (20 minutes default).