Rivers Edge RE713 10' PERIMETER - Manual (Page 5)

TREESTANDS
Page 5
HuntRiversEdge.com
10' Perimeter ™ Ladder Pod (RE713)
HuntRiversEdge.com
800-450-EDGE (3343)
14. Insert the (2) top legs (TP145) into the leg pockets already mounted to
the platform and secure using (2) provided 1/4-20 x 2-1/4” bolts and
locknuts.
SEE FIGURE 7.
15. Insert the bottom legs with feet (TP147) into the top legs. Attach (2) dual
support brace tabs to each joint location of the leg assemblies and secure
those locations using (2) provided 1/4-20 x 2-1/4” bolts and locknuts.
SEE FIGURE 7.
NOTE: Make sure foot pads are orientated out, away from
platform.
16. a. Locate the (4) 12” male cross braces (TP149) and the (4) 60” female
cross braces (TP131). Insert the male cross braces into the female cross
braces.
b. Using (4) provided 1/4-20 x 1-1/4” bolts and locknuts, secure 2 cross
braces in the hole location listed for pole length A and 2 cross braces in
the hole location listed for pole length B.
SEE FIGURE 8.
wARNING
BE CERTAIN ALL LADDER AND LEG SECTIONS HAVE
THE BOLTS GOING THROUGH PROVIDED HOLES IN
EACH SECTION. DO NOT CRUSH TUBING wHEN
TIGHTENING.
DOUBLE AND TRIPLE CHECK ALL NUT AND BOLTS TO
MAKE SURE ALL HAVE BEEN TIGHTENED SECURELY.
FIGURE 7
(2) dual support brace tabs
ladder foot pad
(facing outward)
(2)1/4-20 x 1-1/2" bolts
(4) 1/4-20 x 2-1/4"
locknuts
locknuts
(4) 1/4-20 x 1-3/4" bolts
locknuts
J-receiver tubes
(4) 1/4-20 x 1-3/4" bolts
FIGURE 8
A (appx. 67")
B (appx. 63-1/4")
double flat brace
(2 total)
(2 total)
(1 total)
12" male crossbraces
60" female cross braces
1/4-20 x 1-1/4" bolts and locknuts
(4) single support
brace tabs