Rivers Edge RE713 10' PERIMETER - Manual (Page 4)

TREESTANDS
10' Perimeter ™ Ladder Pod (RE713)
Page 4
HuntRiversEdge.com
HuntRiversEdge.com
800-450-EDGE (3343)
NOTE: Nylon washers should be placed between side rails and
backrest rim for noise elimination.
10. Attach the shooting rail front rail to the shooting rail side rails using (2)
provided 1/4-20 x 1-1/4” bolts and locknuts. SEE FIGURE 6. Side rails
should be inserted into the front rail and bolts should go through both
rails.
11. a. Attach the removable seat cushion (48126) to the top of seat
frame. Wrap the Velcro straps around seat frame and secure
together. Pull straps tight so seat is not loose.
b. Attach backrest pad (48858) to the backrest rim by wrapping
around metal tubing and attaching Velcro together.
c.Attach the 66” camo sleeve (48874) to the shooting rail by
wrapping around metal tubing and attaching Velcro together. The pad
will act as a noise dampener between shooting rail and armrests.
12. Attach the ladder foot pads (TP113) to the bottom (short) ladder (TP159)
using (2) provided 1/4-20 x 1-1/2” bolts and locknuts. SEE FIGURE 7.
This step now makes this the bottom ladder section.
NOTE: Channel on foot pads should touch on three sides of the
ladder legs. SEE FIGURE 7.
13. Insert the top ladder (SL51) onto the J-receiver tubes already mounted
on platform and the bottom ladder assembly onto the top ladder. Attach
(4) single support brace tabs (TP115) to each joint location of ladder
assembly and secure those locations using (4) provided 1/4-20 x 1-3/4”
bolts and locknuts.
SEE FIGURE 7.
NOTE: Make sure foot pads are orientated out, away from
platform.
wARNING
LUBRICATION IS HIGHLY RECOMMENDED AT SLIDE
TOGETHER POINTS OF EACH SECTION TO PREVENT
BINDING. SECTIONS ARE STACKED TOGETHER BY
SLIDING SECTIONS TOGETHER, INSIDE OF EACH
OTHER.
BE SURE ALL LADDER AND LEG SECTIONS ARE SEATED
COMPLETELY TOGETHER ON POCKETED ENDS OF
PIPE.
FIGURE 6
locknuts
armrests
1/4-20 x 2" bolts
nylon washers
1/4-20 x 2" bolts
backrest rim
steel washers
seat frame
1/4-20 x 1-1/4" bolts
shooting rail front
1/4-20 x 1-1/4" bolts
shooting rail sides
NOTE: Longer side of
armrest here
NOTE: Longer side of
side rail here