Rivers Edge RE509 Big Foot XLT - Manual (Page 6)

Check for parts online at www.huntriversedge.com or call 800-450-EDGE (3343) M-F 8-5 Check for parts online at www.huntriversedge.com or call 800-450-EDGE (3343) M-F 8-5 6
Operator's Manual
Rivers Edge Hang-On Stands
8
AssEMBlY INsTRuCTIONs (RE504, RE500,
RE501, RE503, RE506, RE507)
Tools needed – two 7/16" wrenches
IMPORTAnT AssEMBLY TIP: do not tighten any nut and bolt combi-
nations completely until all parts are assembled together! Finger
tighten plus one turn of a wrench only! This will temporarily hold the
lock nut on the bolt while helping alignment of all parts! After all parts
are assembled together, all nut & bolt combinations must be com-
pletely tightened.
1. Bolt the metal seat frame (C30) or (C33) onto the seat post using the (2)
provided 1/4-20 x 2-1/4" bolts, locknuts and (6) nylon washers. sEE
fIGuREs 1A OR 1B. DO NOT tighten all nut & bolt assemblies
completely!
2. Attach removable seat cushion to metal seat frame by sliding seat
frame into pocket. Wrap the Velcro seat straps or buckle straps
around seat frame and secure together. Snap the side release buckle
together for buckle style seats. Pull straps tight so seat is not loose.
3. Bolt cables onto platform using the (2) provided 1/4 x 1-1/2" bolts,
locknuts and steel washers. sEE fIGuRE 2. You must now tighten all
nut & bolt assemblies. Be sure not to over tighten or crush tubing
when tightening!
nOTE: using powder graphite lubricant during assembly of moving
parts will help eliminate noise during use!
4. Attach backpacking straps (48067) at desired location on platform.
Fold strap in half. Feed folded strap through platform mesh. Feed the
two loose ends of strap through folded loop and pull tight forming a
cinch knot. sEE fIGuREs 3A AND 3B. Feed straps through platform
mesh and secure with provided tri-slide buckles. sEE fIGuREs 3C.
Figure 1B
Figure 2
platform cable
1/4-20 x 1-1/2" bolts
steel washers
locknut
1/4-20 x 2-1/4" bolts
locknuts
nylon washers
Figure 1A
nylon washers
nylon washers
1/4-20 x 2-1/4" bolts
nylon washers
locknuts
Figure 3A Figure 3B
Figure 3C
seat frame
seat post
seat frame
seat post