Warning – Rivers Edge RE750 Universal Treestand Canopy User Manual
Page 5

TREESTANDS
Page 5
HuntRiversEdge.com
Universal Treestand Canopy (RE750)
HuntRiversEdge.com
800-450-EDGE (4)
ALwAYS...
• Be physically fit, mentally alert, and well rested before using this product.
• Read, understand and follow all warnings and instructions before use and
save for future reference
• Recommended for adult use only.
• Inspect canopy for missing parts, all hardware condition, and damage
before every application, replace if necessary.
• Remove canopy after every use, store product indoors.
• Use only Rivers Edge original replacement parts.
• Always inform someone of the hunting location, where you will be located
and the expected duration of the hunt.
• Carry a signal device such as a mobile phone, radio, whistle, signal flare
or personal locator device (PLD) and it must be readily available at all
times.
• Inspect the canopy and all safety devices each time before use and do
not store a canopy outdoors when not in use.
NEVER...
• Sleep in a treestand
• Attach to a dead, odd-shaped, leaning, diseased, loose barked trees or
utility poles.
• Use on trees with a diameter smaller than 8 inches or no larger than 20
inches.
• Use a canopy or treestand during inclement weather such as rain,
lightning, windstorms or icy conditions and end your hunt and return to
the ground if inclement conditions arise.
• Alter the original design of your canopy.
• Jump on or use in a careless manner.
• Use when intoxicated or using over-the-counter medication or
prescription drugs.
• Use a damaged product, replace with new.
• Loan your canopy to someone else.
• Use a canopy or treestand when feeling ill, nauseous or dizzy, or if you
have a prior medical condition that could cause a problem, i.e., heart
condition, joints that lock-up, spinal fusion, etc. or if your are not well
rested.
wARNING
PERfORM THESE TASkS BEfORE EACH AND EVERY
USE. (REPLACE ANY QUESTIONABLE COMPONENTS
IMMEDIATELY wITH RIVERS EDGE ORIGINAL REPLACE-
MENT PARTS.)
INSTRUCTIONS SHOULD BE kEPT IN A SAfE PLACE
AND REVIEwED AT LEAST ANNUALLY.
REPLACE ANY AND ALL TREESTAND STRAPS EVERY
TwO YEARS OR wHEN ANY SIGNS Of DAMAGE OR
wEAR EXIST BEfORE.
NEVER USE ANY PRODUCT THAT HAS NOT BEEN MAIN-
TAINED OR INSPECTED PROPERLY - YOUR LIfE DE-
PENDS ON IT!
BE SURE TO RAISE AND LOwER YOUR wEAPON wITH A
HAUL LINE. GUN BARREL END OR ARROw TIPS MUST
BE POINTED DOwN-AwAY fROM YOU.
wHEN HUNTING fROM A TREESTAND, fALLS CAN OC-
CUR ANY TIME AfTER LEAVING THE GROUND CAUSING
INJURY OR DEATH.
INSPECTION AND MAINTENANCE SCHEDULE
fOR ALL RIVERS EDGE PRODUCTS
• Inspect all webbing, rope, cord, and strap assemblies for wear or damage.
• Inspect cables and cable ends for damage or kinking.
• Inspect all hardware and chain components for damage.
• Inspect for any structural damage to product. (Return to factory for repair or
discard product if any damage is found.)
• Inspect all nut and bolt assemblies to be certain none are loose.
• Inspect for any missing parts.
• Lubricate all pivot and slide together points with powder graphite to prevent noise,
wear, and rust.
• Inspect entire product for any rust, corrosion, cracks, freezing, excessive
heat, or rotting damage that may effect the safety of your product. Discard
any questionable product.
• Inspect entire product for any structural damage - pay close attention to all
weld locations. (Return to factory for repair or discard product if any damage
is found.)
• Using correct wrenches inspect all nut & bolt assembly locations and snug
up any that may be loose. Be careful not to crush tubing when tightening!
• Inspect and check operation of all cables, cable ends, cord, rope, webbing,
and strap or chain assemblies. Replace with factory new any item or assembly
that shows signs of wear, damage, kinking, or functions incorrectly.
• Inspect seat. Replace any seat with factory new that shows signs of structural
damage or wear.
• Inspect all hardware for wear or damage, also be sure you have no missing
parts.
• Never modify your stand in any way by making repairs, replacing parts, or
altering adding or attaching anything to it except if explicitly authorized in
writing by the manufacturer.