Rivers Edge RE761 TREE SEAT TREE LAX LOUNGER - Manual (Page 3)

TREESTANDS
Page 3
HuntRiversEdge.com
Tree lax lounger ground Tree seat (re761)
HuntRiversEdge.com
800-450-edge (3343)
Figure
seTuP and use insTruCTions
1. This tree seat is designed to be used at a height that allows the user's
feet to be on the ground at all times when in use. Use as a ground seat
only.
2. Attach the long strap to either upper corner of backrest frame. Wrap the
loop end of strap around the backrest rim and feed opposite end of strap
through the loop. Pull tight forming a cinch knot. This permanently attaches
this strap to the backrest rim.
see Figure .
3. repeat step 2 for strap with ratchet by attaching it to the opposite upper
corner of backrest rim. Wrap the loop end of strap around the backrest
rim and feed the ratchet assembly through the loop. Pull tight forming a
cinch knot. This permanently attaches this strap to the backrest rim.
see
Figure 3.
4. Standing on ground, wrap long strap around tree and feed the long strap
through the center (slot) of ratcheting mechanism and back around through
tightening lever.
see Figure 4.
NOte: be sure you feed the long strap correctly so there are no
twists in the strap.
Pull tail of long strap until most of the slack is taken out. Be sure entire
strap is even and at the same level all around tree. "ratchet" tight to tree,
this will securely attach the tree seat to tree and prevent movement.
see
Figure 5. Make sure all (4) contact points of frames are touching tree
(two on tree hugger and two on backrest loop). Always test before sitting
on the seat.
NOte: to release ratchet, simply pull the release lever and open
tightening lever wide open (flat).
5. Adjustment in height may be needed for comfort. redo setup instructions
as necessary to achieve a comfortable seat height from the ground. Never
attach this ground seat at a height that will not allow you to have both feet
on the ground at all times during use.
6. reverse setup and use instructions to take tree seat down
warning
do noT allow eXCessive sTraP BuilduP in raTCH-
eT as THis will PrevenT THe raTCHeT TeeTH FroM
engaging Causing sliPPage.
always aTTaCH raTCHeT sTraP seCurely wHile
using THis ProduCT!
never sTand on ground seaT; iT is designed For
siTTing only.
Figure 5
Figure 3
TREE
ratchet
back and forth
pull tail to take out slack
tightening lever
release lever
feed through slot
Figure 4