Autostart AS-6105 SH User Manual
Page 19
AS-6105 SH Installation Guide P.19
10 x = Alarm condition
Intrusion Codes
1 x = Power-up Reset: Battery
disconnected / reconnected or
dead…
2 x = Doors intrusion
3 x = Shock Sense
4 x = Hood
5 x = Panic
6 x = Ignition
Note: “x” stands for one flash of the Parking Lights
Intrusion Codes via LED light
If there has been an intrusion in the vehicle while it was locked and armed, the LED will
provide an intrusion code corresponding to the type of the intrusion which took place. The
LED intrusion codes are flashed in continuous loops. They are the same codes as those
provided during Events Playback:
1 x = Power-up Reset: Battery
disconnected / reconnected or
dead…
2 x = Doors intrusion
3 x = Shock Sense
4 x = Hood
5 x = Panic
6 x = Ignition
Chirps
Chirps
Description
1
x
LOCK
and
ARM
the system.
x
LOCK
confirmation
.
x Entering Mode 1 in Programming Options.
x Start attempt when the Engine is already running under remote control.
x Disarmed Notification
2
x
UNLOCK
and disarm.
x Transmitter Programmed.
x Entering Mode 2 in Programming options.
3
x
LOCK
and arm while a zone is left unprotected.
x Entering Mode 3 in Programming Options.
x Door zone left unprotected.
4
x
UNLOCK
and disarm: an intrusion was detected.¸
x Entering Tach-learning Mode.
5
x Siren or Horn Chirp Timing adjustment
Constant up to 30
seconds
x Panic Mode causes the Horn/Siren to sound.
Constant up to
60 seconds
x Alarm condition generated by an intrusion, by triggering Panic Mode, or
when the Module is powered up.