Ransburg Evolver NE A11279-XX, A11281-XX, A11775-XX, A11776-XX - Manual (Page 10)

INTRODUCTION
5
Evolver NE Solventborne Robotic Atomizers - Introduction
Environmental / Physical
Robot/Mounting
Compatibility: All hollow wrist robots
Operating Temperature
Range: 55 °F (12.8°C) - 131°F (55°C)
Weight
Dual-Head W/Manifold:
60 ° 8.6 lbs. (3.9 Kg)
90 ° 8.3 lbs. (3.8 Kg)
Single-Head W/Manifold:
60 ° 7.9 lbs. (3.6 Kg)
90 ° 7.6 lbs. (3.5 Kg)
Length
Dual-Head:
60 ° 7 3/4" (19.69 cm)
90 ° 9" (22.86 cm)
Single-Head:
60 ° 7 1/4" (18.42 cm)
90 ° 8 3/4" (22.22 cm)
Tubing Manifolds (English):
A11071-1XX 15' (4.57m)
A11071-2XX 30' (9.14m)
Paint Flow Rate: Variable to 1500 cc/min.
(Depending on viscosity & configuration)
Trigger Response
Time: 150m sec. open
220m sec. closed
Operating Air Pressures
Atomizing Air: 100 psig max. (6.9 bar)
Fan Air: 100 psig max. (6.9 bar)
Trigger Air: 70 psig min./100 psig
max. (4.8 - 6.9 bar)
Regulator Pilot: 70 psig min./100 psig
max. (4.8 - 6.9 bar)
Dump Pilot: 70 psig min./100 psig
max. (4.8 - 6.9 bar)
Operating Fluid
Pressure: 100 psig max. (6.9 bar)
SPECIFICATIONS The Evolver NE (Non-Electrostatic) TM Solventborne Ap-
plicators consists of both 60 ° and 90° dual-head and
60 ° and 90° single-head spray applicators. Developed
for use on robots, the Evolver applicator incorporates
a unique 1/3 turn quick-disconnect spray head.
The dual-head applicators are primarily used where
high volume fluid delivery is required. The dual-head
applicator is available in two different configurations
as follows (see Figure 2B):
A11279-XX 60 ° Dual-Head
A11281-XX 90 ° Dual-Head
The single-head applicatorss are primarily used
where lower volume of fluid delivery is required. The
single-head applicator is available in two different
configurations as follows (see Figure 2B) :
A11775-XX 60 ° Single-Head
A11776-XX 90 ° Single-Head
The Evolver Spray Applicator System consists of four
major components:
1. Quick-Disconnect Spray Head
2. Applicator Head Mounting Block Assembly
3. Valve Manifold Assembly (Includes the
Quick-Disconnect Ring)
4. Rear Tubing Manifold Assembly
The spray head(s) and valve manifold contain the fluid
and air passages. All fluid passages contain stainless
steel and/or nylon fittings, compatible with haloge-
nated hydrocarbon solvents. The robot manifold
incorporates stainless steel fluid connections.
(Continued On Next Page)
AA-05-01.5