Ransburg DR-1 Plastic Fluid Regulator LREG5001 - Manual (Page 9)

INTRODUCTION
SPECIFICATIONS
Air Pressures: Variable by Control
(Manual or Automatic)
Fluid Input: 100 psi (6.8 bar max.)
(10 psi minimum above
output pressure)
Fluid Output: Variable by Ratio
Pneumatic / Fluid Connections
Air Pilot: 1/8-inch NPT x 1/4-inch
Tube (Low and High)
Fluid In: 7/16-20 UNF - 37° Flare
1/4-inch OD Tube, use
LSFI0022-04, Fitting
3/8-inch OD Tube, use
LSFI0022-07, Fitting
Fluid Out: 1/8-inch NPT
1/4-inch OD Tube, use
LSFI0041-01, Fitting
3/8-inch OD Tube, use
LSFI0041-02, Fitting
Volume of Paint
Held Within
Regulator: 5 cc
Mechanical
Height: 4-1/2-inch (114mm)
w/fittings
Diameter: 4-inch (102mm)
w/fittings
Environmental / Physical
FEATURES
• Two independently controlled flow pressure
ranges.
• High flow range port for higher fluid deliveries.
• Low flow range for more precise control over
lower fluid deliveries.
• Interchangeable low flow ratios (1:1, 1:2, 1:3,
1:4, 1:6, 1:8, 1:10) for precise control.
• Plastic and coated wetted parts for
decreased color change time.
• Factory Mutual listed in conjunction with the
Aerobell 33 TM .
DR-1 Plastic Fluid Regulator - Introduction
Ransburg
6 LN-9221-00.7