LOCKSTATE LS-6600 - Manual (Page 2)

new code
4. Steps for Deleting Users
(1)press “# # ”, (2)enter the master code, (3)press “* # * ”, (4)enter the 3 digit user number,
(5)re-enter the 3 digit user number
5. Steps for Entering One-Button Passage Mode (lock will open when ANY single button is pressed)
(1)press “# # ”, (2)enter master code, (3) press “# # # ”, (4) again press “# # # ”
6. Steps for Exiting One-Button Passage Mode (lock requires access code to open – factory default)
(1)press any button, (2)press “# # ”, (3)enter master code. (4)press“# # #”, (5)again press“# # # ”
How to Change the Cylinder
The LockState cylinder is especially designed to be easily changed and re-keyed. Whether you
are re-keying the LockState LS-6600 yourself or having a professional re-key it for you, the
simple steps below show how to easily change out the cylinder or re-key the lock.
1. Use tool 1 to pull the cover off the handle and expose the keyway.
2. Then pull off the small plastic cap from the handle side hole and use tool 2 to unscrew the
hexangular screw.
3. Insert the key into the cylinder and continue to turn it counter-clockwise until the old cylinder is
free to be pulled out.
4. Remove the stem cap from the old cylinder.
5. In the next steps you will place the stem cap from the old cylinder on the new cylinder.
6. Remove the tailpiece (stem) from the new cylinder.
7. Put the stem cap from the old cylinder on the new cylinder.
8. Insert the new cylinder into the handle and rotate clockwise until secure.
9. Replace the hexangular screw and plastic cap in the handle side hole.