King Kooker Fire Pit - Manual (Page 11)

11
sAndbAG FIllInG InstructIons
Locate the sandbag provided with the appliance. Approximately 35 lbs. of sand (not included) is
required to fill the sandbag. Follow the below steps to fill the sandbag with sand -
1. Locate the opening of the sandbag and fill with sand to just below the first set of strings
provided on the outside of the sandbag (approximately 1/3 the length of the sandbag.)
2. Loop the strings around the sandbag and pull and tie the strings tightly to seal off the
first third of the sandbag.
3. Continue to fill the sandbag to just below the second set of strings provided on the
outside of the sandbag (approximately 2/3 the length of the sandbag.)
4. Loop the strings around the sandbag and pull and tie the strings tightly to seal off the
next third of the sandbag.
5. Continue to fill the sandbag to just below the last set of strings provided on the outside of
the sandbag.
6. Loop the strings around the sandbag and pull and tie the strings tightly to seal off the
last third of the sandbag.
The filled sandbag must be placed around the base of the 20 lb. cylinder before operating your
appliance. Wrap the filled sandbag around the base of the cylinder and tie the two ends of the
sandbag together with the strings provided. Make sure the sandbag is properly placed around the
base of the propane cylinder as shown in Figure 1 below before operating your appliance. Go to the
Use and Care section for further instructions.
FAIlure to Follow tHese InstructIons And wArnInGs could result In FIre,
exPlosIon, burn HAzArd or cArbon monoxIde PoIsonInG wHIcH could cAuse
ProPerty dAmAGe, PersonAl InJury or deAtH.
sAndbAG
FIGure 1
sAndbAG
20 lb.
lP GAs
cylInder
FAIlure to InstAll tHe sAndbAG Around tHe bAse oF tHe cylInder cAn IncreAse
tHe rIsK oF tHe cylInder tIPPInG. tHe sAndbAG must be FIlled And PlAced As
Per tHe AboVe InstructIons beFore oPerAtInG your APPlIAnce.