King Kooker Jet and Combination Burners - Manual (Page 17)

17
For models wIth
non-AdjustAble
regulAtors wIth
mAnuAl VAlVes
1. Check that the casting is properly
located as per the diagram and
that the orifice is properly located in
respect to the jet pipe. (Figure 1)
2. Make certain that the manual valves
are turned to the OFF position by
turning them clockwise until they
reach the stop position.
3. Open the cylinder control valve by
turning it counterclockwise as per
the diagram (Figure 2).
4. To light the jet burner, hold a multi-
purpose lighter or paperback match
over the jet pipe as per (Figure
3). Turn the corresponding manual
valve control toward the ON position
until ignition occurs. Turning the
manual valve counterclockwise
increases the gas flow to the burner
and hence the flame size (Figure
2). To light the cast burner, hold
a multipurpose lighter or use a
paperbook match placed above the
casting as per (Figure 4). Turn
the corresponding manual valve
control toward the ON position until
ignition occurs. Turning the manual valve counterclockwise increases the gas flow to the burner
and hence the flame size (Figure 2). When lighting the stove, if ignition does not occur in 3 to
5 seconds, turn the manual valve(s) and cylinder control off. Wait 5 minutes for gas to disperse.
Repeat Procedure.
5. Refer to (Figure 5) for proper flame emission for the jet and cast burners. The casting flame should
be blue and the flame should be emitted from every port in the casting. If not, rotate the air shutter
position until there is a blue flame. Opening the shutter too much will cause the flame to “lift” off
the burner. If there is a yellow flame, or if some ports have no flame, this indicates there may be an
obstruction in the venturi tube or ports. Check the maintenance instructions on page 18 for more
information regarding a yellow flame.
6. Always monitor the flame throughout the cooking process. If at any point in the cooking process
the flame(s) are accidently extinguished, immediately turn the manual valve(s) and cylinder valve
OFF. Wait 5 minutes for gas to disperse and relight the cooker according to the lighting insructions
(#1 - #5) in this section.
neVer put hAnds or FAce dIrectly oVer burner whIle lIghtIng
or whIle the ApplIAnce Is lIt.