Havener 22DP22BP24SP with Vertical Shaft Engine User Manual
Page 6
5
SPECIAL SERVICE INSTRUCTIONS
Check oil level before every mowing.
Change Oil every eight to ten hours of operation. Use high quality SAE 30 oil.
Use unleaded gasoline.
Keep your engine clean. Dirt and grass accumulation can result in serious damage to the precision parts of
your engine.
ENGINE SERVICE
Refer to engine owner’s manual.
CAUTION: BE SURE TO HANDLE FUEL OUTDOORS, AWAY FROM SPARK OR FLAME.
LUBRICATION
To lubricate your Even Cut Mower, apply bearing grease through the fitting on the hub housing. .You may use
an air pressure or hand-held grease gun. To lubricate the wheels on your Even Cut Mower high quality
grease may be packed inside the wheel hubs.
CUTTING HEIGHT ADJUSTMENT
Your Even Cut is adjustable to a accommodated your cutting height requirements by lower and raising the
front and rear wheels.
BLADE SHARPENING-CAUTION
CAUTION: WHEN ADJUSTING, REPLACING OR MOVING THE MOWER BLADE, THE SPARK PLUG
WIRE MUST BE DISCONNECTED TO AVOID ACCIDENTAL STARTING.
CLEANING YOUR EVEN CUT MOWER
Clean your Even Cut after each use. Let the engine cool, and then wipe the grass and debris from mower
and engine. Check mower pan for grass and dirt build-up. Disconnect the spark plug and tip mower on its
side (muffler side up) to clean underneath deck. Check the blade and mounting hardware at frequent
intervals for wear and tightness. Replace worn parts with Even Cut original equipment parts for safety.