Gentec-EO MACH 5 - Manual (Page 10)

Mach 5 User’s Manual Revision 2.1 10
Range LED. Should either of these conditions occur, contact GENTEC-EO for service of
the unit.
The Applications Software
The Mach 5 Application Software consists of controls and indicators on 6 display tabs:
1. The Instrument Controls Display.
2. The Strip Chart Display.
3. The Histogram Display.
4. The Statistics Display.
5. The FFT Display.
6. The Probe Data Display
The desired display is selected by clicking on the appropriate tab.
The Main Controls
Figure 3 shows the Instrument Controls Display of the Applications Software.