General Pump 72 Series Gearbox - Manual (Page 8)

GENERAL PUMP
A member of the Interpump Group
Gearbox-71 & 72 Series
Page 8
Insert the packing (Fig. 9) and assemble the gear housing, taking care to fit the hole onto the correct pin present on the
crankcase (Fig. 10, position 1).
Fasten the gear housing with the 6 M8 x 50 screws and tighten the latter with a torque wrench (Fig. 11 and 12) as
indicated in section 9.
Insert the crown into the pump shaft, apply the washer and use the wrench (Fig. 13) to tighten the screws to the torque
level indicated in section 9. Fix the two Ø5 pins to the gear housing (Fig. 14, position 1).
Ref 300761 Rev.B
12-11