AEG LAVAMAT 50265 - Manual (Page 38)

Installation and connection instructions
38
Installation and connection instructions
Installation Safety Precautions
• Do not tilt the washing machine onto its front or onto its right side
(viewed from the front). Electronic components can get wet.
• Check the washing machine for transport damages. A damaged unit
must never be put into operation under any circumstances. In the
event of damage, please contact your supplier.
• Ensure that all parts of the transport safeguard are removed and that
the unit is splash protected, see "Removing transport safeguard".
Otherwise, the units or neighbouring furniture can be damaged when
spinning.
• Always insert the plug into a correctly installed earthed socket.
• In the case of permanent connection: A permanent connection may
only be made by an authorised specialist.
• Before putting the machine into operation, ensure that the mains
voltage and current type shown on the unit's rating plate correspond
with those at the place where the machine is being installed. The fuse
rating is also found on the rating plate.
• Should work be carried out on the water supply installations in order
to allow the machine to be connected properly to the water supply,
this work must be carried out by an authorised installer.
• Should work be carried out on the mains supply in order to allow the
machine to be connected properly to the electricity supply, this work
must be carried out by an authorised electrician.
• The mains lead may only be replaced by the customer service or by an
authorised electrician.