Bosch GSN36BW30 Congelatore verticale Bianco - Manual (Page 26)

en
26
Controls
Fig. 2
Switching
the appliance on
Fig. 2
Switch on the appliance with the On/Off
button 1/8.
A warning signal sounds.
The temperature display 1 flashes
and the alarm display 3 is lit.
Press the “alarm” button 7. The warning
signal switches off and the temperature
display 1 stops flashing.
When the freezer compartment has
reached its set temperature, the alarm
display 3 goes out.
Operating tips
■ After the appliance has been switched
on, it may take several hours until
the set temperature has been
reached. Do not put any food
in the appliance beforehand.
■ The fully automatic No Frost system
ensures that the freezer compartment
remains free of ice. Defrosting is not
required.
■ The sides of the housing are
sometimes heated slightly. This
prevents condensation in the area
of the door seal.
■ If the freezer compartment door
cannot be immediately re-opened after
it has been closed, wait until
the resulting low pressure has
equalised.
1 Temperature display freezer
compartment
The numbers correspond
to the set freezer compartment
temperatures in °C.
2 Display super freezing
Illuminates when super freezing is
on.
3 Alarm display
Lights up if the freezer
compartment becomes too warm.
It goes out when the freezer
compartment has reached the set
temperature.
4 Energy saving mode display
It is lit when the appliance is not
in use.
5 Temperature selection buttons
freezer compartment
These buttons set
the temperature in the freezer
compartment.
6 “Super” button (freezer
compartment)
Switches super freezing
on and off.
7 Alarm button
Used to switch off the warning
signal, see chapter “Alarm
function”.