AEG FAVORIT 88050 I - Manual (Page 38)

Operating Instructions
38
After remedying the O , ` or \ error, shut the door.
After rectifying an Å 10 or Å 20 error, press the button for the dishwa-
shing cycle that has been started. The dishwashing cycle will continue.
If the fault is displayed again, please contact customer service.
3 For all other errors displayed, please contact customer service, stating
the error code. (See chapter “Customer Service”).
Three short continuously
repeated warning tones can
be heard, error code
Å 30 is
displayed in the multi-dis-
play.
The leak prevention system
has been triggered.
Turn off the tap and
contact customer ser-
vice.
One long continuously
repeated warning tone can
be heard; the O indica-
tor is continuously illumina-
ted.
The middle spray arm is
jammed.
Open the door care-
fully. Hot steam may
escape when the door is
opened. There is a risk of
scalding. Arrange the
dishes and cutlery in the
racks so that the spray
arm above can rotate
freely. Close the dishwa-
sher door.
The
`
indicator is conti-
nuously illuminated.
The door of the dishwasher
is open. Close the dishwasher
door.
The
\
indicator is conti-
nuously illuminated:
The indicator
\
is only
intended to remind you to
occasionally check the dish-
washer’s filter and to clean
it out when necessary. It
becomes illuminated at
regular intervals, regardless
of the state of cleanliness of
the filter.
The indicator goes out
automatically at the
start of the next dish-
washing cycle.
Malfunction Possible cause Remedy