Frieling MILKchiller™ 0601 - Manual (Page 20)

20
Troubleshooting
The MILKchiller™ is plugged
in, however, the display is
blank.
Make sure the cord is securely plugged into
the power supply and the Power Switch is in
the ON position.
The MILKchiller™ is plugged
in and the Switch is in the ON
position and the display is
blank.
Call the MILKchiller™ HOTLINE for
service.
If the MILKchiller™ is turned
off will I lose my settings?
No, the MILKchiller™ will have the same
settings at the next start-up.
The display continues to
flash “COOLING” 2 hours
after powering ON the
MILKchiller™.
Remove and discard the contents of the
MILKchiller™.
Turn the MILKchiller™ OFF, wait 3 seconds
then turn ON.
Use a new container of dairy product that has
been refrigerated at the proper temperature.
If problem persists, call the MILKchiller™
HOTLINE for service.
There was a power failure for 2
or more hours, is the milk safe?
It is recommended not to serve dairy products
that have not been cooled for over 2 hours.
If there is a power failure during business
hours, remove the container from the chilling
chamber and place in refrigerator. Turn the
MILKchiller™ to OFF for the duration of the
power failure.
Please remember to remove the container
from the chilling chamber and store it
overnight in the refrigerator. This will avoid
the dairy product spoiling overnight in the
event of an extended power outage.
Power ON the MILKchiller™ ™ after the
power has been restored.
When loading a ½ gallon
carton, liquid escapes from the
Disposable Straw.
Some ½ gallon containers are filled to the
top, causing milk to escape.
Pour out 2 oz. of liquid prior to inserting the
Disposable Straw.
When the push button is
pressed, the LOW indicator
flashes, even with a full carton
of dairy product installed.
This is normal, the force of pressing the push
button triggers the LOW indicator. It will
disappear when the push button is released,
unless the liquid level is actually LOW.