FEC AFC1200 - Manual (Page 7)

)(& ,QF
DSUB 9-pin female communication connector. (Option) RS422 25
(NOT USED) 24
(NOT USED) 23
DSUB 15-pin female VGA CRT (monitor) connector. May be
used to connect an optional LCD Display. CRT 22
DSUB 9-pin male input connector. RS232C CH2 21
MINI DIN 6-pin keyboard/keypad connector. K / B 20
Backup battery for System clock. (INSIDE - NOT VISIBLE) 19
(NOT USED) 18
200~230 VAC, 50/60 Hz, single phase input power
connector. AC-POWER AC200~230V 17
DSUB 9-pin male output connector. RS232C CH1 16
DSUB 25-pin female Centronics parallel printer connection. PRINTER 15
Interface connector for System input/output control lines.
(Refer to Chapter 4 for details) PLC2 14
Interface connector for System input/output control lines.
(Refer to Chapter 4 for details) PLC1 13
Hard disk drive, IDE interface. (INSIDE - NOT VISIBLE) 12
Manual pushbutton for Calibration (Cal) Check. (MANUAL) CAL 11
Manual pushbutton to reverse tool rotation. (MANUAL) REV 10
Manual pushbutton for fastening start. (MANUAL) START 9
Manual pushbutton for System reset and Zero Check. (MANUAL) RESET 8
Operation mode selector (key) switch. RUN mode allows
equipment to operate, and PROGRAM is the data entry
(presetting) mode. RUN / PROGRAM 7
Rotary switch for selecting which items are to be displayed
on the Axis Unit at DSP1 and DSP2. (Refer to the Axis Unit
Display Table in Section 3.2.4) AXIS-DSP 6
Display LED (orange) that indicates when either a Cal Check
or a Zero Check is being performed. CHECK 5
Display LED (orange) that indicates when the fastening cycle
is in process. BUSY 4
Display light (red) that indicates when an unacceptable
fastening, Zero Check, or Cal Check is complete. REJECT 3
Display light (green) that indicates when an acceptable
fastening, Zero Check, or Cal Check is complete. ACCEPT 2
Floppy disk drive: 3.5" 1.44MB Notebook computer style. FDD 1
DESCRIPTION (REFERENCE FIGURE 3-2-3) ITEM AS MARKED ON UNIT
AFC1200 ISA MAIN CONTROLLER UNIT - CONTROLS AND INDICATORS
Chapter 3: System Description
Page 3-7