Elite Screens Insta-DE2 - Manual (Page 4)

081513-JA 4 www.elitescreens.com
10. Lift edges and smoothen out any remaining air bubbles.
Caution
The smoothing tool’s edge is sharp. Carefully scrape the screen when removing air bubbles to avoid scratching
the surface.
11. Peel off the top layer of the double-sided tape and flatten the screen’s edges with the smoothing tool.
12. Use a soft damp towel or sponge to clean entire surface.
Adhesive black velvet border installation
1. Measure the top/bottom and left/right sides of the Insta-DE2 screen to obtain the required length of the velvet
border you will need to use for bordering your screen.
2. Peel a small portion off of the velvet border and place it about half an inch over the white area of the screen.
Continue to peel off and roll out the remainder of the velvet border until you have reached the end and cut the
edge.
Note: For best results we recommend cutting the edge in a 45° angle.
3. Repeat the process for the remainder of the sides until all sides are bordered as shown below.