Installation – Elite Screens Insta-DE2 User Manual
Page 3
020514-JA
www.elitescreens.com
3
Installation
Watch the installation video at:
1. Smoothen the entire surface of the wall with sandpaper.
2. Clean the entire surface with a wet sponge or lint-free towel to remove any dust left from sanding the
wall.
3. Measure and draw line around the screen installation area.
4. Apply the included double-sided tap over the line. Do not remote the top film of the tape
5. Pour an entire powder bag into a paint bucket filled with 27 oz. of room temperature water and stir until
all lumps are gone and the compound has a syrup texture. This will make the mixture into an adhesive
compound for sticking the film to the wall.
Note: Once the compound has been mixed, it must be applied within 4 hours to ensure a sealed
installation of the Insta-DE2 to the wall. Use one bag for every 27 oz. of water.
6. Pour the mixture into a paint tray and dip the roller.
7. Apply a thin coat of adhesive to the surface evenly with a paint roller.
8. Once the adhesive has dried, sand the surface to ensure no adhesive residue is left on the wall.
9. Then, apply/spray water on the surface to regain the stickiness from the compound glue.
10. Unroll the Insta-DE2 on to the wall lining it up with the drawn line from Step 3.
Note 1: Each side of the material is labeled FRONT/BACK
Note 2: Do not allow the material to wrinkle or crease to avoid permanent damage.
9. Flatten the surface with a flexible wall smoothing tool in a 45 degree angle to avoid scratching the
surface.
Wall
cecececece