Electronics International FL-2 - Manual (Page 20)

FL FL FL FL FL-2CA -2CA -2CA -2CA -2CA
Wiring Diagram Wiring Diagram Wiring Diagram Wiring Diagram Wiring Diagram
Circular Connector
3' Analog LED Lighting Control Line, connects to Panel Light Rheostat.
12/24 volts dims the analog LEDs.
3' ( Optional) External Warning Control Line. Can be connected to a
relay to control an external light, buzzer, etc. Grounds when Red
Warning Light is on. Current must be limited to 1/10 amp maximum.
3' Backlight Control Line, connects to 24 Volt Bus via 1 amp fuse (may
use the power fuse). Connect to ground for 12 Volt System.
3' Backlight Control Line, connects to 12 Volt Bus via 1 amp fuse (may
use the power fuse). 12 volts turns on the digital display backlight.
3' Ground Lead, connects to Ground.
3' Power Lead, connects to 12 or 24 Volt Bus via 1 amp fuse or circuit
breaker.
White/Yel
Black
Red
White/Brwn
White/Red
White/Orng
Wire Harness
Do not use screws Do not use screws Do not use screws Do not use screws Do not use screws
longer than 1/2" (4 ea.). longer than 1/2" (4 ea.). longer than 1/2" (4 ea.). longer than 1/2" (4 ea.). longer than 1/2" (4 ea.).
23 23 23 23 23
18
Red Wire
6' Grouped wires marked "Left", connects to Left Tank Capacitive Sensor. Black Wire
White Wire
Red Wire
6' Grouped wires marked "Right", connects to Right Tank Capacitive Sensor.
Black Wire
White Wire