Teledyne 7500 - Infrared gas analyzer - operating manual - Manual (Page 38)

38 Model 7500 Instruction Manual
Teledyne Analytical Instruments
6.2.4 Setting of auto-calibration component
It sets the CH (component) to be calibrated in the auto-
calibration.
1. During measurement, press the MODE key to display
the User mode.
2. Point the cursor to “Setting about Calibration” by
pressing the UP or DOWN key. Press the ENT key.
3. In the “Setting about Calibration” screen that appears,
point the cursor to “Auto Calibration Components” by
pressing the UP or DOWN key. Press the ENT key.
4. In the “Auto Calibration Components” selection screen
that appears, point the cursor to the CH you want to set
by pressing the UP or DOWN key. Press the ENT key.