Teledyne 238 - Thermal conductivity analyzer User Manual
Page 38
Teledyne Analytical Instruments
A-2
Appendix
Model 235
Calibration Data
The following data, along with any Addenda that may be included in
the front part of this manual, pertain to your specific Thermal Conductivity
Analyzer.
Calibration data for Model:
______________________
Serial Number:
______________________
Range:
______________________
Non-measured components:
______________________
Output Signal:
______________________
Reference and Zero Gas:
______________________
Note: If the zero gas contains a known (or equivalent) impurity,
the zero control should be set so that the analyzer indi-
cates the impurity during the standardization procedure.
Span Gas:
______________________
Selected Resistor Values:
______________________
______________________
______________________
______________________
Alarm Strapping:
______________________
Zero Setting:
______________________
Span Setting:
______________________