Autostart AS-1484iHF - Manual (Page 4)

P. 4 User Guide
Remote-Starting
Press the
START/STOP
button for approx. 1 second. The parking lights will come ON, informing
you that the unit has received your signal. Approx. 5 seconds later, the engine will start. The
Parking Lights will remain ON during the pre-programmed run time.
If the vehicle doesn’t start the first time, the system will shut down.
Driving Off
With the vehicle running under remote control, press the
UNLOCK
button to
DISARM
and
UNLOCK
the doors (if installed). Enter the vehicle and do the following:
• Turn the ignition key to the
IGNITION ON (RUN)
position.
• Press the brakes to disengage the remote starter unit.
You are now ready to drive off.
Caution: do not turn the key to the
CRANK
position with the engine running. This will cause
the starter motor to re-engage, unless your vehicle is equipped with the Start Kill / Anti-
Grind Feature (Optional).
Remote Starter Features
Idle Mode
This feature allows the user to engage the remote starter to take over the vehicle while it is
already running with the key in the
IGNITION
switch. The vehicle will keep running for the pre-
programmed run time, or until it is shut down by remote.
Caution: Do not leave children or pets unattended in a car running in Idle Mode.
To activate Idle Mode:
To enable Idle Mode, press and hold the
LOCK
,
UNLOCK
or
START/STOP
button on your remote
transmitter while the engine is running.
Note: When enabling Idle Mode, pressing
LOCK
or
UNLOCK
will automatically unlock the
doors.
The parking lights will come
ON
. Remove the key, exit the vehicle and lock the doors (if
desired). Pressing the
TRUNK
button at this point will lock all Doors and activate Idle Mode.
The engine will continue running and will turn itself
OFF
when the pre-programmed run time
expires (see Step 6 of the “Setting the system to Ready Mode” section on p. 3).
Valet Modes
Ignition Valet
The system can be placed in Valet Mode to disable the remote starting capabilities. If the
vehicle needs to be serviced, or if you park it indoors, Valet Mode will prevent the engine
from being accidentally started by remote control.
To ENTER Valet Mode
1. With the key in the Ignition switch, turn the key to the
ON (RUN/IGNITION)
and then
OFF
positions 5 times within 10 seconds.
2. The Parking Light will flash 3 times indicating the Module is now in Valet Mode.
The LED will turn
ON
solid.
To EXIT Valet Mode
1. With the key in the Ignition switch, turn the key to the
ON (RUN/IGNITION)
and then
OFF
positions 5 times within 10 seconds.
2. The Parking Light will flash twice indicating the Module is now out of Valet Mode.
The LED will turn
OFF
.
Valet Mode using the Valet Button
(If installed)
To put the system into Valet Mode: