Cleaning the floor nozzle, Care – Bosch LithiumPower 18V Aspirateur balai sans fil rechargeable BCH51840 PABL User Manual
Page 36
35
Fig.
16
Cleaning the filter cartridge
•
Switch off the appliance.
•
Remove the dust container from the appliance.
Fig.
12
•
Take the filter unit out of the dust container.
Fig
.
13
a) Turn the filter cartridge lid anti-clockwise and remove
the filter cartridge from the filter unit.
b) Firstly, clean the filter cartridge by tapping out the dirt.
c) Then, under running water, rinse out the filter
cartridge, foam filter and motor protection filter
together or separately from each other. If the foam
filter is heavily contaminated, the filter cartridge can
also be cleaned in the washing machine at a maximum
temperature of 30 °C and at the lowest spin speed.
Allow the foam filter and motor protection filter
to dry completely (approx. 24 hours)
d) After fitting the foam filter, insert the filter cartridge
into the dust container.
e) Insert the filter cartridge into the filter unit and lock it
by turning the lid clockwise.
New filters can be obtained from our after-sales
service, if required.
Cleaning the floor nozzle
Before carrying out any maintenance, switch off the
vacuum cleaner and disconnect it from the charging
cable.
Fig.
17
a) Release the brush roller using the release button and
pull it sideways out of the floor nozzle.
b) Using the groove provided, cut through threads and
hairs wound round the rollers with scissors and then
remove them.
c) Push the brush roller in sideways along the guide rod in
the floor tool and lock in place using the release button.
!
Caution: The floor nozzle must only be put into ope-
ration with the brush roller fitted.
Care
Before cleaning the hand-held vacuum cleaner, it must
be switched off and disconnected from the charging
cable. The vacuum cleaner and plastic accessories can
be cleaned with an ordinary plastic cleaner.
!
Caution: Do not use abrasive materials, glass-
cleaning agents or all-purpose cleaning products.
Never immerse the vacuum cleaner in water.
Subject to technical modifications.
* Depending on model