APW Wyott CDO-17 - Manual (Page 4)

!
WARNING: This symbol refers to a potential hazard or unsafe practice, which could result in
serious injury or death.
!
! !
DANGER: This symbol warns of imminent hazard which will result in serious injury or death.
! !
CAUTION: This symbol refers to a potential hazard or unsafe practice, which may result in minor or
moderate injury or product or property damage.
! !
NOTICE: This symbol refers to information that needs special attention or must be fully understood
even though not dangerous.
SAFETY PRECAUTIONS
Before installing and operating this equipment be sure everyone involved in its operation are fully trained
and are aware of all precautions.Accidents and problems can result by a failure to follow fundamental rules
and precautions.
The following words and symbols, found in this manual, alert you to hazards to the operator, service
personnel or the equipment. The words are defined as follows:
! ! WARNING: This product is intended for commercialuse only. Not for householduse.
!
CAUTION: These models are designed, built, and sold for commercial use. If these models are
positioned so the general public can use the equipment make sure that cautions, warnings, and
operating instructions are clearly posted near each unit so that anyone using the equipment will
use it correctly and not injure themselvesor harm the equipment.
!
! ! WARNING: - SHOCK HAZARD Do not open any panels that require the use of tools.
! ! NOTICE: THESE PROCEDURES MUST BE PERFORMED BY QUALIFIED PERSONNEL OR
WARRANTYWILLBE VOIDED..
! !
WARNING: Improper installation, adjustment, alteration, service or maintenance can cause
property damage, injury or death. Read the installation, operating and maintenance instructions
thoroughlybefore installing or servicing this equipment.
! !
NOTICE: The unit when installed, must be electrically grounded and comply with local codes, or in
the absence of local codes, with the national electrical code ANSI/NFPA70- latest edition.
Canadian installation must comply with CSA-STANDARD C.22.2 Number 0 M1982 General
Requirements-CanadianElectrical Code Part II, 109-M1981-CommercialCookingAppliances.
! !
NOTICE: Local codes regarding installation vary greatly from one area to another. The National
Fire Protection Association, Inc. states in its NFPA96 latest edition that local codes are “Authority
Having Jurisdiction” when it comes to requirement for installation of equipment. Therefore,
installation should comply with all local codes.
SPECIFICATIONS
Electrical:
Dimensions Unit:
Heating Elements:
CDO-17 120 Volts, 50/60 Hz, 13 amps, 1 Phase, 1.5 KW
208/240 Volts, 50/60 Hz, 7.7/9.0 amps, 1 Phase, 1.6 KW/21.4 KW
21-3/4" W x 25" 0 x 18.75" H
Three metal sheath heaters; one over the top shelf, one under the top shelf, and one
under the bottom shelf.Athermostat is provided for selecting the desired temperature.Afifteen-minute timer
is provided for customer convenience.
! WARNING: Check the data plate on this unit before installation. Connect the unit only to the voltage
and frequency listed on the data plate. Connect only to 1 or 3 phase as listed on the data plate.
!
4