beautypg.com

Weak battery, Jumper cables, Operation – Poulan Pro 301ZX_966681701 LAWN TRACTOR User Manual

Page 27

background image

OPERATION

27

10. Slowly pull back on the choke control when the

engine has started.

11. Set the desired engine speed with the throttle.

Allow the engine to run at a moderate speed,
“half throttle” for 3-5 minutes before loading it to
heavily. USE FULL THROTTLE WHEN MOWING

(no choke).

WARNING!

Engine exhaust and certain vehicle
components contain or emit
chemicals considered to cause
cancer, birth defects, or other
reproductive system damage. The
engine exhaust contains carbon
monoxide, which is a odorless,
colorless, poisonous gas. Do not use
the machine in enclosed spaces.

8050-007

Use full throttle when mowing

8011-642

Jumper cable connection

IMPORTANT INFORMATION

Your mower is equipped with a 12-volt
negative grounded system. The other vehicle
must also be a 12-volt negative grounded
system. Do not use your mower to start other
vehicles.

If your battery is too weak to start the engine, it should
be recharged. (See Battery in the Maintenance

section.)
If jumper cables are used for emergency starting,
follow this procedure:

Jumper cables
1. Connect each end of the RED cable to the

POSITIVE (+) terminal on each battery, taking
care not to short against chassis.

2. Connect one end of the BLACK cable to the

NEGATIVE (-) terminal of the fully charged battery.

3. Connect the other end of the BLACK cable to a

good CHASSIS GROUND on the mower with the
discharged battery, away from the fuel tank and
battery.

To remove cables, reverse order
1. Remove BLACK cable first from chassis and then

from the fully charged battery.

2. Remove RED cable last from both batteries.

WARNING!

Lead-acid batteries generate
explosive gases. Keep sparks,
flame and smoking materials away
from batteries. Always wear eye
protection when around batteries.

Weak Battery