Poulan Pro 301ZX_966681701 LAWN TRACTOR - Manual (Page 42)

LUBRICATION
42
8050-009
Lubricating the wheel bearings
Engine Lubrication
Refer to the engine manufacturer's manual for
maintenance and service instructions.
8058-076
Lubricating the steering control shafts
Front Wheel Mount
Lubricate with a grease gun, one zerk for each wheel
mount, until the grease is forced out.
Use only good quality bearing grease.
Grease from well-known brand names (petrochemical
companies, etc.) usually maintains a good quality.
Front Wheel Bearings
Lubricate with a grease gun, one zerk for each set of
wheel bearings, until the grease is forced out.
Use only good quality bearing grease.
IMPORTANT INFORMATION
Use minimal lubrication and remove excess
lubricant so that is does not come into contact
with belts or belt pulley drive surfaces.
8050-027
Lubricating the deck spindle after removing the foot plate
Deck Spindle
Lower the cutting deck completely.
If you use grease gun without rubber hose, remove
the foot plate to access deck spindle zerk.
Lubricate with a grease gun, one zerk, 2-3 strokes.
Use only good quality bearing grease.
Steering Control Shafts
Tip the driver’s seat.
Lubricate with a grease gun, one zerk for each
steering control shaft, until the grease is forced out.
Use only good quality molybdenum disulphide
grease.
Grease from well-known brand names (petrochemical
companies, etc.) usually maintains a good quality.
Transmission
The transmission is maintenance free with no need for
level checks or oil changes. If a leak occurs, replace
the unit or contact your Poulan dealer.