Bosch TES50651DE VeroCafe LattePro Kaffeevollautomat Helles Anthrazit Morning Haze - Manual (Page 35)

31
TES506.. | 02/2014
en
Level Water hardness
German (°dH) French (°fH)
1
2
3
4
1-7
8-14
15-21
22-30
1-13
14-25
26-38
39-54
Drink counter
This displays how many drinks have been
dispensed since the appliance was first put
into operation.
Adjusting the
grinding unit
The rotary selector (3) adjusts the grind
settings from coarse to fine.
¡
Warning!
Adjust the grinding unit only while it is
running! Otherwise the appliance may be
damaged. Do not reach into the grinding
unit.
● While the grinding unit is running, adjust
the rotary selector (3) from fine ( a: Turn
anticlockwise) to coarse ( b: Turn clock-
wise) as required.
a b
Note: The new setting will not become
apparent until after the second cup of
coffee.
Note: If the message Please adjust
grinding unit to coarser setting!
appears in the display, the grind setting
for the coffee beans is too fine. Adjust the
grinding unit to a coarser setting.
Tip: For dark roast coffee beans, choose a
finer grind, for lighter beans a coarser grind.
Preparation using
coffee beans
This fully automatic espresso machine
grinds beans freshly for each brew.
The appliance must be ready for use. To
prepare a coffee­based drink with milk, first
insert the milk tube into a milk container and
turn the rotary selector (6b) to “Milk froth”
j
.
Important: Dried milk residue is difficult
to remove, so the milk frother (6) must be
cleaned with lukewarm water immediately
after use and rinse using the Rinse milk
system programme.
Tip: If possible, use only beans for fully
automatic coffee and espresso machines.
For optimal quality, deep-freeze the beans
or store in a cool place in sealed containers.
Coffee beans can be ground while frozen.
Important: Fill the water tank (17) with
fresh water every day. The tank (17) should
always contain sufficient water for operating
the appliance.
Preparation
1. Place the pre-warmed cup(s) under the
coffee outlet (7).
Tip: For a small espresso, always
preheat the cup, e.g. using hot water.
2. Select the required coffee and the
required per-cup quantity by turning the
upper rotary knob (15). The selected
coffee and the per-cup quantity are
shown in the display.
3. Select the required coffee strength by
turning the lower rotary knob (14). The
selected coffee strength is shown in
the display. To prepare two cups at the
same time, press the
d
button (11)
(only for drinks without milk and without
the aromaDouble Shot function).
4. Press the start button (10).
Coffee is brewed and then poured into the
cup(s).